Developed from the ground up, we wanted to build a truly Multi-rotor specificthat would offer the best performance and value in the market today. We wiped the slate clean and looked to the community for inspiration and help in designing an that truly could be known as “The Multi-rotor ”
Enter Simon and Hamasaki AKA SimonK and timecop. This combination of hardware and firmware expertise in conjunction with the Hobbyking in house engineering team gave us the edge needed to develop anlike no other and hence the Afro series was born.
Boasting high efficiency, all N-channel MOSFET design, jitter-free hardware PWM input, and smooth power response the Afroseries are set to change the expectations of multi-rotor pilots around the globe. The Afro series ship with multi-rotor specific SimonK software preloaded! No need to reflash. For added convenience the Turnigy USB linker can be used via the PWM signal lead for any future software updates eliminating the need for complicated flashing jigs or the need to cut open the heat shrink.
MikroKopter I2C compatibility has also been built in as standard. A DIY port is available under the shrink wrap which allows using the with MikroKopter hardware that uses I2C control.
Current Draw: 20A Continuous
Voltage Range: 2-4s
BEC: 0.5A Linear
Input Freq: 1KHz
Discharge wire/plugs: 16AWG/Male 3.5mm
Motor wire/plugs: 16AWG/Female 3.5mm
Weight: 22.8g (Included wire, plug, heat shrink)
Size: 45 x 25.7 x 10.5mm
Royalties paid on each unit sold to SimonK and Hamasaki for their design work, without which the Afrowould never have been born, thanks guys!
- Additional Information
Processor No Architecture No Clock Speed No Digital Pins No Analog Pins No PWM Pins No Hardware UART No Programming Interface No Flash Memory No Operating Voltage No Power Output No Antenna No Range (Indoor/Urban) No Range (Outdoor/RF Line of Sight) No Channel Capacity No Frequency No Transmit Current @ 3.3V No