The APM Power Module is a simple way of providing your APM or Pixhawk with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6-pos cable. The on-board switching regulator outputs 5.3V and a maximum of 2.25A from up to a 4S LiPo battery. The Power Module comes completely assembled with XT60 connectors, and wrapped in shrink tubing for protection.
Note: The Power Module is only designed to power APM or Pixhawk, an RC receiver and APM or Pixhawk accessories (GPS, 3DR Radio). It is NOT designed to power servos. Use your aircraft's or copter's own ESC/BEC for that.
- Max input voltage: 18V
- Max current sensing: 90A
- Voltage and current measurement configured for 5V ADC
- Switching regulator outputs 5.3V and 2.25A max
- 6-pos DF13 cable plugs directly to APM 2.5's 'PM' connector or Pixhawk's 'Power' Connector
- Eagle files
- Dimensional drawing
- Additional Information
Processor No Architecture No Clock Speed No Digital Pins No Analog Pins No PWM Pins No Hardware UART No Programming Interface No Flash Memory No Operating Voltage No Power Output No Antenna No Range (Indoor/Urban) No Range (Outdoor/RF Line of Sight) No Channel Capacity No Frequency No Transmit Current @ 3.3V No