1.) Comes Fully Assembled and Ready to Use (There is a choice between the type of BreadBoards for which you will use the BBPS-SMD).
2.) Compatible with standard BreadBoards like Solderless BreadBoard 830 tie-points and 840 tie-points.
3.) Two Power Inputs available - DC Jack or Screw Terminals.
4.) Two separate Low Drop Out (LDO) Voltage Regulators for 5V and 3.3V outputs.
5.) Capable of supplying 5V as well as 3.3V simultaneously to both Power Rails of the BreadBoard, say, Top Power rail may run at 5V (for Microcontroller Circuit) and the Bottom Rail may run at 3.3V (for Sensor Interfacing).
6.) Reverse Protection Diode on-board.
7.) In-built Thermal Overload Protection circuit.
8.) Vout at 5V is capable of supplying 800mA at normal load and even slightly above 1A in case you need it.
9.) Vout at 3.3V will be able to easily supply 300mA.
10.) Power 'On' LED Indicator.
The BreadBoard Power Supply - Fully Assembled version will come with headers pre-soldered as per your choice below:
830 tie-point compatible Headers will be compatible with the Solderless BreadBoard.
840 tie-point compatible Headers will be compatible with an 840 tie-points BreadBoard.
If you are confused about the type of headers, we will throw in a pair of headers so that you may solder them yourself [I'll decide later].Documents:
- Additional Information
Processor No Architecture No Clock Speed No Digital Pins No Analog Pins No PWM Pins No Hardware UART No Programming Interface No Flash Memory No Operating Voltage No Power Output No Antenna No Range (Indoor/Urban) No Range (Outdoor/RF Line of Sight) No Channel Capacity No Frequency No Transmit Current @ 3.3V No