PPM encoder allows you to connect your PWM-only RC equipment to PPM-only autopilot systems, like Pixhawk. Smaller than 3D Robotics' previous PPM, their encoder will enable you to reduce all your channels to a single wire, excluding ground and power wires. As a result, you'll get faster processing and reduced points of error.
3DR PPM encoder includes:
- PPM encoder module
- PPM input cable to PWM receiver DF13 10-position to servo (7 cm)
- PPM output cable to autopilot DF13 three-position to servo (12 cm)
- ATmega 328 p microcontroller, firmware upgradeable via an AVRISP programmer
- 22 x 19 x 5.5 mm (without cables)
- 1.45 g
Schematics | Learn more about open-source hardware
Released under the Creative Commons Attribution Share-Alike 4.0 International License
Designed by 3D Robotics Inc.
- Additional Information
Processor No Architecture No Clock Speed No Digital Pins No Analog Pins No PWM Pins No Hardware UART No Programming Interface No Flash Memory No Operating Voltage No Power Output No Antenna No Range (Indoor/Urban) No Range (Outdoor/RF Line of Sight) No Channel Capacity No Frequency No Transmit Current @ 3.3V No