USB Host Shield

USB Host Shield
Excl. Tax: Rs. 1,189.52 Incl. Tax: Rs. 1,249.00

Be the first to review this product

SKU: SFE-09947
by Sparkfun

Availability: In stock

The USB Host Shield contains all of the digital logic and analog circuitry necessary to implement a full-speed USB peripheral/host controller with your Arduino. This means you could use your Arduino to interface with and control any USB slave device - thumbdrives, digital cameras, bluetooth dongles, and much more!

Description

Details

This new version corrects the pin out for the GPX and RESET pins. The USB Host Shield contains all of the digital logic and analog circuitry necessary to implement a full-speed USB peripheral/host controller with your Arduino. This means you could use your Arduino to interface with and control any USB slave device - thumbdrives, digital cameras, bluetooth dongles, and much more!

A four-wire serial interface is used to communicate with the host controller chip, so the shield connects the Arduino's hardware SPI pins (D10-13) to the MAX3421E. A USB type A female connector is wired up to the IC, and it also supplies 5V as any normal USB port would.

The Host Shield takes its power from the 'Vin' pin on your Arduino. Power from that pin is regulated to both 5V and 3.3V on the shield. All SPI signals are sent through a hex converter to step them down to 3.3V.

Documents:

Additional Information

Additional Information

Processor No
Architecture No
Clock Speed No
Digital Pins No
Analog Pins No
PWM Pins No
Hardware UART No
Programming Interface No
Flash Memory No
Operating Voltage No
Power Output No
Antenna No
Range (Indoor/Urban) No
Range (Outdoor/RF Line of Sight) No
Channel Capacity No
Frequency No
Transmit Current @ 3.3V No
Reviews